Det finnes ingen tilgjengelige oversettelser.

CornerTape - Tips & Tricks

	All corners must be masked before doing the long runs. Simply cut 3 pieces of CornerTape. Start in one corner approx. 1 cm from the gap. Remove the clear film. Repeat on the other sides. Then mask up the long runs and overlap onto the pre-masked corner. For a 2-way corner, don’t remove the clear film from the 3rd side of the joint, this will then block the sealant.		Take the forming tool which is included and simply slide it in-between the clear and silvertapes. Start a little way down from the end of the tape, not at the very top.
	If you are struggling to remove the metal tape, use the back of the clear plastic film. Attach the film to the metal tape and pull gently.		Take the forming tool and slide in-between the two tapes and press it right into the corner. Now just fold over the tape and lightly press the other half of it down. Don’t run the tool down the joint, but repeat these two steps every 50 cm.
	Now very gently, starting in the middle, fold the tape over to the left side of the corner, making sure the crease of the tape stays in the corner at all times.		The enclosed forming tool is especially shaped to fit in the preset sized gap of the CornerTape. Be sure to hold the forming tool at an even angle, smoothing down the whole joint in one long run.
	Keep the forming tool at a fixed angle, approx. 90*. The edges of the forming tool will coincide with the edge of the tape, thus avoiding edges to your joint.		Here you see the results of the holding of the forming tool: To the left: held in a fixed angle of approx 90 degrees To the right: held in a much smaller angle creating an edge to your joint.
	If you are having trouble removing the white backing paper, try to bend the corner of the tape till the white backing paper releases itself from the thin metal tape.		If you have applied too little silicone, simply apply another thin bead. If you have applied too much silicone, simply wipe the former tool of on a piece of paper and continue smoothing down the joint.
	To ensure proper application of the CornerTape, it is vital that you use the CornerTape grip. With your right hand - give yourself the “tumbs up”. Now place that thumb inside the core of the roll, holding it against the wall. Now extend your index finger just a little bit on the outside of the roll, and with a light pressure secure the roll to the opposite wall. This will ensure that the roll stays in the corner applying the tape correctly.		Use the CornerTape grip, and always let the roll be the guide as to where you apply the CornerTape.